Network Working Group B. Elliston
Request for Comments: 2143 Compucat Research
Category: Experimental May 1997
Encapsulating IP with the Small Computer System Interface
Status of this Memo
This memo defines an Experimental Protocol for the Internet
community. This memo does not specify an Internet standard of any
kind. Discussion and suggestions for improvement are requested.
Distribution of this memo is unlimited.
Table of Contents
1. Introduction . . . . . . . . . . . . . . . . . . . . . . . 1
2. Brief background to the Small Computer System Interface . 2
3. Link Encapsulation . . . . . . . . . . . . . . . . . . . . 3
4. An Address Resolution Protocol . . . . . . . . . . . . . . 4
5. Scalability . . . . . . . . . . . . . . . . . . . . . . . 4
6. Possible applications . . . . . . . . . . . . . . . . . . 5
7. Security considerations . . . . . . . . . . . . . . . . . 5
8. References . . . . . . . . . . . . . . . . . . . . . . . . 5
9. Author's Address . . . . . . . . . . . . . . . . . . . . . 5
1. Introduction
As the capacity of local area networks increases to meet the demands
of high volume application data, there is a class of network
intensive problems which may be applied to small clusters of
workstations with high bandwidth interconnection.
A general observation of networks is that the bit rate of the data
path typically decreases as the distance between hosts increases. It
is common to see regional networks connected at a rate of 64Kbps and
office networks connected at 100Mbps, but the inverse is far less
common.
The same is true of peripheral and memory interconnection. Memory
close to a CPU's core may run at speeds equivalent to a gigabit
network. More importantly, devices such as disks may connect a
number of metres away from its host at speeds well in excess of
current local area network capacity.
Elliston Experimental [Page 1]
RFC 2143 Encapsulating IP with the SCSI May 1997
This document outlines a protocol for connecting hosts running the
TCP/IP protocol suite over a Small Computer System Interface (SCSI)
bus. Despite the limitation in the furthest distance between hosts,
SCSI permits close clusters of workstations to communicate between
each other at speeds approaching 360 megabits per second.
The proposed introduction of newer SCSI implementations such as
serial SCSI will bring much faster communication at greater
distances.
2. Background to the Small Computer System Interface (SCSI)
SCSI defines a physical and data link protocol for connecting
peripherals to hosts. Devices connect autonomously to a bus and send
synchronous or asynchronous messages to other devices.
Devices are identified by a numeric identifier (ID). For the
original SCSI protocol, devices are given a user-selectable SCSI ID
between 0 and 7. Wide SCSI specifies a range of SCSI IDs between 0
and 15. The most typical SCSI configuration comprises of a host
adapter and one or more SCSI- capable peripherals responding to
asynchronous messages from the host adapter.
The most critical aspect of the protocol with respect to its use as a
data link for the Internet protocols is that a SCSI device must act
as an "initiator" (generator of SCSI commands/requests) or a "target"
(a device which responds to SCSI commands from the initiator). This
model is correct for a master/slave relationship between host adapter
and devices. The only time an initiator receives a message addressed
to it is in response to a command issued by it in the past and a
target device always generates a response to every command it
receives.
Clearly this is unsuitable for the peer-to-peer model required for
multiple host adapters to asynchronously send SCSI commands to one
another without surplus bus traffic. Furthermore, some host adapters
may refuse to accept a message from another adapter as it expects to
only initiate SCSI commands. This restriction to the protocol
requires that SCSI adapters used for IP encapsulation support what is
known as "target mode", with software device driver support to pass
these messages up to higher layer modules for processing.
Elliston Experimental [Page 2]
RFC 2143 Encapsulating IP with the SCSI May 1997
3. Link Encapsulation
The ANSI SCSI standard defines classes of peripherals which may be
interconnected with the SCSI protocol. One of these is the class of
"communication devices" [1].
The standard defines three message types capable of carrying a
general-purpose payload across communication devices. Each of these
are known as the "SEND MESSAGE" message type, but the size and and
structure of the message header differs amongst them. The three
forms of message header are six (6), ten (10) and twelve (12) bytes
long.
It was decided that the ten byte header offers the greatest
flexibility for encapsulating version 4 IP datagrams for the
following reasons:
a. The transfer length field is 16 bits in size which is perfectly
matched to the datagram length field in IP version 4.
Implementations of IP will run efficiently as datagrams will
never be fragmented over SCSI networks.
b. The SCSI "stream select" field, which was designed to permit
a device to specify the stream of data to which a block
belongs, may be used to encode the payload type (in a similar
manner to the Ethernet frame type field). For consistency, the
lowest four bits of the "stream select" field should match the
set of values assigned by the IEEE for Ethernet protocol types.
Encapsulating an IP datagram within a SCSI message is
straightforward:
+------------------+-----------------------------------+
| SCSI header | IP datagram |
+------------------+-----------------------------------+
The fields of the SCSI header should be completed as follows:
Byte 0: 0x2A (SEND_MESSAGE(10) opcode)
Byte 1: Logical unit number encoded into top 3 bits | 0x00
Byte 2: 0x00
Byte 3: 0x00
Byte 4: 0x00
Byte 5: Protocol type encoded into lowest 4 bits | 0x00
Byte 6: 0x00
Bytes 7/8: IP datagram length, big endian representation
Byte 9: 0x00
Elliston Experimental [Page 3]
RFC 2143 Encapsulating IP with the SCSI May 1997
4. An Address Resolution Protocol
When IP decides that the next hop for a datagram will be onto a SCSI
network supported by a SCSI IP network interface implementation, it
is necessary to acquire a data link address to deliver the datagram.
Network interfaces such as Ethernet have well-known methods for
acquiring the media address for an Internet protocol address, the
most common being the Address Resolution Protocol (ARP). In existing
implementations, the forwarding host "yells" using a broadcast media
address and expects the named host to respond.
The SCSI protocol does not provide a broadcast data link address. An
acceptable solution to the address resolution problem for a SCSI
network is to simulate a broadcast by performing a series of round-
robin transmissions to each target. Depending on the SCSI protocol
being used, this would require upward of seven independent bus
accesses. This is not grossly inefficient, however, if combined with
an effective ARP caching policy. A further possible optimisation is
negative ARP caching, whereby incomplete ARP bindings are not queried
for some period in the future.
5. Scalability
While the utility of a network architecture based around a bus
network which can span less than ten metres and support only eight
hosts may be questionable, the flexibility of IP and in particular,
IP routing, improves the scalability of this architecture.
Consider a network of eight hosts connected to a SCSI bus in which
each host acts as a multi-homed host with a second host adapter
connecting another seven hosts to it. When configured with IP packet
routing capability, each of the 64 total hosts may communicate with
one another at high speed in a packet switched manner.
Depending on the I/O bus capabilities of certain workstations, it may
also be possible to configure a multi-homed host with a greater
number of SCSI host adapters, permitting centralised star
configurations to be constructed.
It should be apparent that for little expense, massively parallel
virtual machines can be built based upon the IP protocol running over
the high-bandwidth SCSI protocol.
Elliston Experimental [Page 4]
RFC 2143 Encapsulating IP with the SCSI May 1997
6. Possible Applications
Research has been made into the capability of "networks of
workstations", and their performance compared to supercomputers. An
observation that has been made thus far is that bottlenecks exist in
the channels by which executable code is transported between hosts
for execution. A very high-speed network architecture based around
the Internet protocol would permit a seamless transition of existing
application software to a high-bandwidth environment.
Other applications that have been considered are server clusters for
fault-tolerant NFS, World-Wide Web and database services.
7. Security Considerations
Transmitting IP datagrams across a SCSI bus raises similar security
issues to other local area networking architectures. The scale of
security problems relating to protocols above the data link layer
should be obvious to a reader current in Internet security.
8. References
[1] ANSI X3T9 Technical Committee, "Small Computer System
Interface - 2", X3T9.2, Project 375D, Revision 10L, September
1993.
9. Author's Address
Ben Elliston
Compucat Research Pty Limited
Box 7305 Canberra Mail Centre
Canberra ACT 2610
Australia
Phone: +61 6 295 1331
Fax: +61 6 295 1855
Email: ben.elliston@compucat.com.au
Elliston Experimental [Page 5]
|
